Skip to Main Content
STAAD.Pro Ideas Portal

Welcome to the STAAD.Pro Ideas portal. The purpose of this site is to post ideas for enhancements and new features. We value your feedback and our team regularly reviews your suggestions for consideration in future releases.

You have 3 options for providing feedback:

  1. Vote for an existing Idea. The popularity of an Idea helps us understand its importance to our users.

  2. Comment on an existing Idea. We want to hear your unique point of view.

  3. Add a new Idea. If no existing Idea describes what you would like, add a new one!

When you Vote, Comment, or Add an idea you will also be subscribed to that Idea and will receive status updates. Please note that we may merge or rename Ideas for clarity. Thank you for your support and feedback, it is always appreciated!

ADD A NEW IDEA

All ideas

Showing 391 of 391

Plate Stress Results Aligned to a Consistent Coordinate System

When designing concrete or masonry walls and slabs the rebar typically runs in two orthogonal directions. Because of this we are typically interested in stress results resolved to the slab or wall's local coordinate system. STAAD's analytical mode...
Guest about 4 years ago in  1 Future consideration

PHYSICAL MODELING LOAD COMBINATION SPREADSHEET

I think that the numbering on Load Group, Primary Load Case and Load combination spreadsheet should be customizable. This is very important when dealing with several design parameter and/or analysis load groups.
Guest about 4 years ago in  1 Future consideration

Make Saved Report Setups Available to Any Model

Currently saved report setups are only available to the model it was saved in. The user should have the ability to load a report template that he created that can be used for any job.
Randy Killian about 4 years ago in  1 Future consideration

LINE LOAD ON ANALYTICAL MODEL STAAD PRO CONNECT EDITION

Addition of partition wall load on slab should be added on analytical model in Staad Pro Connect Edition
Joseph Lucas Magare about 4 years ago in  1 Already exists

Leave current load highlighted

In the Loads window when you pick an existing load it highlights that load clearly. However, if you then click into the model window, say, to assign a member to that load, it changes it to a very light grey background. If you are going down the li...
Randy Killian about 4 years ago in  1 Future consideration

Assign panel loading on multiple bays in STAAD physical

The way like STAAD physical has it now allows to create only one by one panels with pressure redistribution only in x or Z direction. Just inclined members in the attached sketch cannot be loaded with parallel or perpendicular directions. Also it ...
Guest about 4 years ago in  1 Future consideration

AUTOMATIC GENRATION OF WIND LOAD AS PER INDIAN CODE

The following improvements should be made to Staad Pro 1.The automatic generation of wind load should be made available to Indian code also apart from American code.It will save lot of time in analysis and manual calculation. 2. Automatic creation...
Guest about 4 years ago in  1 Already exists

ADDITION OF LINE LOAD ON PLATE

Option for adding wall load (partition wall) as line load direct on slab should be added
Joseph Lucas Magare about 4 years ago in  1 Already exists

3D STEEL TRUSS DESIGN

I want to design this kind of steel truss in Staad Pro Connect Edition, should i run analysis in staad space or staad plane which one is correct?
Joseph Lucas Magare about 4 years ago in  1 Will not implement

Stirrup strength

May you add an option for choosing the strength stirrups in RCDC,by default is 250 but when i want to use stirrup of 410 its not possible to change its strength in RCDC
Joseph Lucas Magare about 4 years ago in  0 Future consideration