STAAD.Pro Ideas Portal

Welcome to the STAAD.Pro Ideas portal. The purpose of this site is to post ideas for enhancements and new features. We value your feedback and our team regularly reviews your suggestions for consideration in future releases.

You have 3 options for providing feedback:

  1. Vote for an existing Idea. The popularity of an Idea helps us understand its importance to our users.

  2. Comment on an existing Idea. We want to hear your unique point of view.

  3. Add a new Idea. If no existing Idea describes what you would like, add a new one!

When you Vote, Comment, or Add an idea you will also be subscribed to that Idea and will receive status updates. Please note that we may merge or rename Ideas for clarity. Thank you for your support and feedback, it is always appreciated!

ADD A NEW IDEA

STAAD.Pro

Showing 363 of 363

automatic generation of wind load

The automatic generation of wind load should be made available to Indian code also apart from American code. It will save lot of time in analysis and manual calculation.
Guest almost 4 years ago in  1 Already exists

addition of new beams in existing group definition

currently if anyone need to add the beams in group definition, all the beams including existing added need to be selected. if new beams can be added without selecting existing beams, it will be easier
Guest 10 months ago in  1 Future consideration

Highlight the beam when UDL selected

In load data page when you select any specific UDL or point load, then the UDL or point load associated beam and node shall be auto selected or highlighted. this will help to identify if load applied is at right location or not
Guest 10 months ago in  1 Will not implement

display of design results for different design parameters

It is understood that only for AISC 360 design checks, it is feasible to view the design results for different design parameters & maximum case, while the same is not allowed for other design codes without going in to output file. Appreciate t...
Sreekanth Nuthanapati over 1 year ago in  5 Future consideration

Customization of Auto steel drafter For tapered sections

ear Eng: I was Suggest if we can do the following - generate the drawings with the legend "Rxx" ? - Replace the current table shown in the snapshot with the section properties table attached the snap shot that can show the required
Guest over 1 year ago in  1 Future consideration

Company Logo needs to be changed for every project, that is a tedious practice.

While generating Report, Company Logo needs to be changed for every project, that is a tedious practice. The changes should be permanent and for company.
Guest 10 months ago in  1 Already exists

OpenSTAAD Function to Renumber Node

We request to at the OpenSTAAD function to renumber Nodes just like we do with beams.
Kanagarasu Kandasamy 10 months ago in  1 Future consideration

Add angles measurement tool

It would be helpful to add a measurement of angles function to the program especially when dealing with complicated angles and geometry it will help speed up the modeling process and aid in efficiency.
Josh Morris over 1 year ago in  2 Needs review

Annotate Plate Stresses (Mx, My, Mxy, SQx, SQy)

Within the Annotation Menu, could you include Plates Stresses & Nodal Forces ? This will be very useful to display specific plate /nodal results during compilation of Structural reports. Given that the contours only show a range of values. Thi...
Ola Joda 10 months ago in  2 Future consideration

Keep Node Numbers From Physical Modeler

This might be difficult to implement, but it might be nice if you could label the node numbers in the physical modeler different than used in the analytical modeler so that you could keep those nodes the same. Therefore, they would show up the sam...
Ryan Freund 10 months ago in  3 Needs review